ProSeal 55010 Manual de instrucciones descargar pdf

6345 Nancy Ridge Drive, San Diego, CA 92121

(858) 625-0005 ● (800) 992-2018 ● Fax (858) 625-0010 ● Email: info@auto-care.com

ProSeal

™

U-shaped Garage Door Bottom Seal

Installation Instructions

1. Remove existing garage door bottom seal. Some garage door

manufacturers will pinch the aluminum track to hold the bottom seal

in place. To open a pinched track, insert a flathead screw driver, into

the end of the track, and gently pry open the end, just enough to

allow removal of the old door seal. Both ends of the track may need

to be opened.

2. Make sure any debris in the track has been removed and that it is

clean and dry.

3. Starting at either end of the garage door, insert the ¼” T-Ends,

attached to the ProSeal

™

Garage Door Bottom Seal, into the track.

Next, slide the ProSeal

™

into the track, until it reaches the opposite

side.

4. Using a scissors, trim off the excess ProSeal

™

. If your door seal

track was pinched and you wish to pinch it back together, use pliers

to gently pinch the track back into place.

Made in U.S.A.

6345 Nancy Ridge Drive, San Diego, CA 92121 (858) 625-0005 ● (800) 992-2018 ● Fax (858) 625-0010 ● Email: [email protected] ProSeal™ U-shaped Gara

Sin comentarios

ProSeal 55010 Manual de instrucciones